D
DeepanNegi
Recently I faced a scenario where the routing table had two entries for default route and that too with same metric. After doing some research, I found that if we configure same adapter metric manually for WiFi and Ethernet then we will have two default route with the same metric in the routing table.
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 10.38.145.254 10.38.144.34 25
0.0.0.0 0.0.0.0 10.38.151.254 10.38.150.78 25
How to find which interface will be used to forward traffic?
Continue reading...
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 10.38.145.254 10.38.144.34 25
0.0.0.0 0.0.0.0 10.38.151.254 10.38.150.78 25
How to find which interface will be used to forward traffic?
Continue reading...