A
AlBundy9
We have Olympus microscope with camera which comes with software.
We have normally installed the program from the Olympus on Windows xp sp3 without any problems.
But after that when we want to open the program, it give us this error:
No DLLs were found in the Waterfall procedure
after that I click ok.
and then we receive this error:
LoadLibary (SisMain.dll) failed!
We have contacted Olympus, and they told us to install IPP_5_4_3_Runtime.ZIP
from this page: Olympus Soft Imaging Solutions
But when i click on setup.exe file, and when the setup starts, few seconds later
for no reason the installation disappears... So I dont whether the installation was successful or not.
however when i try to open the program again, it give us the same error.
While I wait for the answer from Olympus, i hope someone can help.
What IPP_5_4_3_Runtime does ? can we simply copy/paste missing dll files ?
or is there another solution for that ?
Thank you
Continue reading...
We have normally installed the program from the Olympus on Windows xp sp3 without any problems.
But after that when we want to open the program, it give us this error:
No DLLs were found in the Waterfall procedure
after that I click ok.
and then we receive this error:
LoadLibary (SisMain.dll) failed!
We have contacted Olympus, and they told us to install IPP_5_4_3_Runtime.ZIP
from this page: Olympus Soft Imaging Solutions
But when i click on setup.exe file, and when the setup starts, few seconds later
for no reason the installation disappears... So I dont whether the installation was successful or not.
however when i try to open the program again, it give us the same error.
While I wait for the answer from Olympus, i hope someone can help.
What IPP_5_4_3_Runtime does ? can we simply copy/paste missing dll files ?
or is there another solution for that ?
Thank you
Continue reading...