O
Othorvath
Hello,
I'm trying to configure Remote Access feature in Windows Server 2012 RC using the wizard, but after a successful configuration I'm getting the following error:
Routes required to send packets to the corporate network have not been published on adapter Ethernet. These routes are required for remote clients to reach the corporate network.
Additionally I have some errors in the event log, like this one:
Network Interfaces monitor has gone from INACTIVE state to WARNING state on 2012.06.09. at 11:36 on LCM-DA02.
The failure heuristic IDs for state change of Network Interfaces are 80000001.
I didn't have any similar problems in CP build. Do you have any information how to correct this? Thanks.
Continue reading...
I'm trying to configure Remote Access feature in Windows Server 2012 RC using the wizard, but after a successful configuration I'm getting the following error:
Routes required to send packets to the corporate network have not been published on adapter Ethernet. These routes are required for remote clients to reach the corporate network.
Additionally I have some errors in the event log, like this one:
Network Interfaces monitor has gone from INACTIVE state to WARNING state on 2012.06.09. at 11:36 on LCM-DA02.
The failure heuristic IDs for state change of Network Interfaces are 80000001.
I didn't have any similar problems in CP build. Do you have any information how to correct this? Thanks.
Continue reading...